Sonotec SONOFLOW CO.55/080 Non-Invasive Ultrasonic Flow Rate Sensor; Tube OD 9.0 mm - 9.6 mm Aluminum

Non-Invasive Ultrasonic Flow Rate Sensor; Tube OD 9.0 mm - 9.6 mm
Sensor Model: 
Aluminum
Sensor Series Family: 
Sonotec SONOFLOW CO.55/080
Applicable Industries: 
Biotech
Food and Beverage
Sonotec SONOFLOW CO.55/080 Aluminum Non-Invasive Ultrasonic Flow Rate Sensor; Tube OD 9.0 mm - 9.6 mm

The Aluminum version is standard & can be used where stainless steel is not preferred or required.

The 080 series sensor is designed for tube size:

Outer Diameter (OD): ~9.0 - 9.6 mm (3/8").
Suggested Inner Diameter (ID): 4.8 - 6.0 mm

Tube #: LS15 & LS17

Measuring method: Ultrasound, two sections of measurements, dry coupling, no couplant required

Calibration: Sensors can be pre-calibrated by A&P Calibrations with NIST traceable certifiability. Calibration can be accomplished by the end user as well.

Interfaces:
Current output for flow rate: 4 - 20 mA
Frequency output for flow rate: 0 - 20 kHz, 5 V digital
RS485 interface: bus-capable
Switching output: configurable as PNP / NPN / Push-Pull, 0 … 30 V

Mounting: Fixed installation: 4 fixing holes M4, 8 mm deep

Media: Acoustically transparent liquids

Sensor materials: Measuring channel: PMMA black

Housing: Aluminum

Operating voltage: 12 ... 30 VDC, maximum ripple 10 %, protection against reverse-polarity

Current consumption: Maximum 30 mA (with open current, frequency and switching output)

Electrical connection: 8-pin M12 Connector, DIN EN 61076-2-101:2012

Shielding: Required: via cable / housing (mounting screws)

Sonoflow 080 flow rate meters are available in ALUMINUM, STAINLESS, or STAINLESS with integrated DISPLAY.