Sonotec SONOFLOW CO.55/120 Non-Invasive Ultrasonic Flow Rate Sensor; Tube OD 14.0 mm Stainless Display

The Stainless Display version offers a digital flow rate display for visual flow confirmation, manual flow rate adjustments, etc. This can be helpful for monitoring applications where the sensor is not connected to PLC. This sensor utilizes a stainless steel housing.
The 120 series sensor is designed for tube size:
Outer Diameter (OD): ~14.0 mm (9/16").
Suggested Inner Diameter (ID): ~10.0 mm
Tube #: LS36
Measuring method: Ultrasound, two sections of measurements, dry coupling, no couplant required
Calibration: Sensors can be pre-calibrated by A&P Calibrations with NIST traceable certifiability. Calibration can be accomplished by the end user as well.
Interfaces:
Current output for flow rate: 4 - 20 mA
Frequency output for flow rate: 0 - 20 kHz, 5 V digital
RS485 interface: bus-capable
Switching output: configurable as PNP / NPN / Push-Pull, 0 … 30 V
Mounting: Fixed installation: 4 fixing holes M4, 8 mm deep
Media: Acoustically transparent liquids
Sensor materials: Measuring channel: PMMA black
Housing: Stainless steel, plastics
Operating voltage: 12 ... 30 VDC, maximum ripple 10 %, protection against reverse-polarity
Current consumption: Maximum 30 mA (with open current, frequency and switching output)
Electrical connection: 8-pin M12 Connector, DIN EN 61076-2-101:2012
Shielding: Required: via cable / housing (mounting screws)
Sonoflow 120 flow rate meters are available in ALUMINUM, STAINLESS, or STAINLESS with integrated DISPLAY.